Zonet BT-201USB Guia do Utilizador descarregar pdf (Página 15)

Set Up Bluetooth Devices

First, make sure Bluetooth is enabled both on your computer and on the GPS device.

Using System Preferences, you will need to pair the device with your computer before

ﬁrst use. In the pairing process, you will get the opportunity to specify a serial device

name. It is recommended you use the suggested default value.

You may now address the device in HoudahGeo by the above speciﬁed name.

Set Up Wintec WBT-201 USB Connection

In order to use the USB connection of your Wintec device, you need to install an

appropriate driver. You may get that driver from Silicon Labs. The Wintec device will be

known to HoudahGeo by the name of "SLAB_USBtoUART".

Set Up a MTK-based Device for USB Connection

The MTK name refers to the GPS chipset used in these devices. Different brands of

MTK-based devices use different USB chipsets. Set-up depends on the USB chipset

used. Some devices need no driver: The Qstarz BT-Q1300 shows up as

usbmodemXXX where XXX varies.

Other devices need Mac drivers to operate. You will need to ﬁnd the appropriate drivers

for your device. Actually, some of these devices use the exact same chipset as the

Wintec WBT-201. For these you need to follow the instructions detailed above.

Some devices may need Bluetooth to be switched on for the USB connection to

operate.

Use of a Serial-to-USB Converter

Serial-to-USB converters require the installation of a driver provided by the converter's

manufacturer. The driver decides of the name by which HoudahGeo will see the device.

E.g. for the KeySpan converters the name to use is "KeySerial1".

Serial devices connected using a serial-to-usb converter may show up either as USB or

serial device. Please check both options.

HoudahGeo: User Guide! 15

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 37 38

Sem comentários

Zonet BT-201USB Guia do Utilizador Página 15